Aalborg TIO Totalizer I/O Flow Monitor/Controller Manual de usuario descargar pdf (Pagina 53)

6. INSTALLATION

6.1 General Directions

• Mounting, electrical installations, parameters configuration, start up, and

maintenance of this instrument may only be performed by trained personnel.

Personnel must read and understand this operating manual before performing

any installation or configuration steps.

• The TIO device should only be operated by trained personnel. All instructions in

this manual are to be observed.

• Ensure that power and all input / output signals are correctly wired

according to the wiring diagram provided in this manual. The housing of the

device should only be opened by trained personnel.

6.2 Hardware Installation

NOTE: Electrostatic discharge may cause permanent damage to the

electronic circuitry. Before installing or connecting any wires, the

installer must discharge himself by touching the building protective

earth ground.

The TIO Totalizer Input / Output Flow monitor / Controller can be attached

(mounted) to the Aalborg7 GFM series flow meters, GFC series controllers or

used stand alone (panel mounted or table top installation).

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 97 98

Sin comentarios

Aalborg TIO Totalizer I/O Flow Monitor/Controller Manual de usuario Pagina 53