Aalborg Vortex Insertion Manual de usuario descargar pdf (Pagina 105)

100

UART Error Codes:

1 - Not Supported Command or Back Door is not enabled.

2 - Wrong # of Arguments.

3 - Address is Out of Range (MR or MW commands).

4 - Wrong # of the characters in the Argument.

5 - Attempt to Alter Write Protected Area in the EEPROM.

6 - Proper Command or Argument is not found.

7 - Wrong value of the Argument.

8 - Reserved.

9 - Manufacture specific info EE KEY (wrong key or key is disabled).

Diagnostic and System events codes and bit position:

Code Event Description Bit position

0 CPU Temp. High 0x0000001

1 Freq > HiLimit 0x0000002

2 High Flow Alm. 0x0000004

3 Low Flow Alarm 0x0000008

4 High Temp Alm. 0x0000010

5 Low Temp Alm 0x0000020

6 High Pres Alm. 0x0000040

7 Low Press Alm. 0x0000080

8 Tot#1 > Limit 0x0000100

9 Tot#2 > Limit 0x0000200

10 OptPulse Queue 0x0000400

11 Flow Turbulen. 0x0000800

12 Flow < Cut Off 0x0001000

13 Event Log Over 0x0002000

14 Data Log Over. 0x0004000

15 System L Event 0x0008000

System Events:

16 PEZO SENS. FAULT 0x0010000

17 TEMP SENS. FAULT 0x0020000

18 PRES SENS. FAULT 0x0040000

19 SER. COMM. ERROR 0x0080000

20 EEPROM ACC ERROR 0x0100000

21 BATTERY FAILURE 0x0200000

22 POWER ON EVENT 0x0400000

23 PASSWORD EVENT 0x0800000

24 FATAL ERROR 0x1000000

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 122 123

Sin comentarios

Aalborg Vortex Insertion Manual de usuario Pagina 105